Hyundai Sonata: Body Side Molding / Delta Garnish Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the delta garnish (A).

2.
Install in the reverse order of removal.
   
•
Replace any damaged clips (or pin-type retainers).
Roof Side Molding Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

Front Wheel Guard Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Hazard Lamp Switch Repair procedures
Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9 ...

Hyundai Sonata LF 2014-2019 Service Manual: Master Cylinder Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly (A). 3. Disconnect the brake fluid level switch connector (A). 4. Remove the brake fluid from the master cylinder reservoir with a syringe.     †...

© 2018-2025 www.hsonatalf.org