Hyundai Sonata: Body Side Molding / Front Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips, nuts, bolts and screws, and then remove the front wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Delta Garnish Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Wheel Guard Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) af ...

Hyundai Sonata LF 2014-2019 Service Manual: Alternator Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this alternator is regulated by the battery voltage detection system. The alternator is regulated by th ...

© 2018-2021 www.hsonatalf.org