| Replacement |
|
|
| 1. |
Using a screwdriver or remover, remove the crash pad under cover [RH] (A).
|
| 2. |
Disconnect the under lamp connector (A).
|
| 3. |
Install in the reverse order of removal.
|
Crash Pad Side Cover Repair proceduresReplacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
C..
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...