| Removal |
| 1. |
Disconnect the battery negative (-) cable. |
| 2. |
Disconnect the battery sensor connector (A). |
| 3. |
Remove the battery negative (-) cable after removing the bolts (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Battery Sensor Description and OperationDescription Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors...
Components and Components Location Components 1. Lower cover2. Steering wheel3. Clock Spring4. Driver Airbag (DAB)5. Remote control switch Repair procedures Replacement 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...