Hyundai Sonata: Smart High Beam / Battery saver function

The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the parking lamp when the key is removed (remote key) or when the driver turns the engine off (smart key) and opens the driver-side door.

With this feature, the parking lamps will turn off automatically if the driver parks on the side of road at night.

If necessary, to keep the lamps on when the engine is turned off, perform the following:

1) Open the driver-side door.

2) Turn the parking lamps OFF and ON again using the light switch on the steering column.

Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever w ...

Headlamp delay function
If the key is removed from the ignition switch or placed in the ACC position or the LOCK/OFF position with the headlamps ON, the headlamps (and/or parking lamps) remain on for about 5 minutes. Howev ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: EPB Switch Repair procedures
Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console assembly. (Refer to Body - “Floor console assembly") 3. Remove the EPB switch after loosening the screws. 4. Install in the reverse order of removal. ...

Hyundai Sonata LF 2014-2019 Owners Manual: To resume Smart Cruise Control set speed
If any method other than the CRUISE toggle switch was used to cancel cruising speed and the system is still activated, the cruising speed will automatically resume when you push the toggle switch up (RES+) or down (SET-). If you push the toggle switch up (RES+), the speed will resume to the recen ...

© 2018-2024 www.hsonatalf.org