| Removal |
| 1. |
Disconnect the battery (-) terminals. |
| 2. |
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly") |
| 3. |
Remove the multimedia jack (A) after disconnect the connector and loosening the mounting screws.
|
| Installation |
| 1. |
Connect the multimedia jack connector. |
| 2. |
Install the multimedia jack. |
| 3. |
Install the floor console assembly. |
AUX jack Description and OperationDescription The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3 etc...
Mic Repair proceduresInspection 1. Disconnector the negative (-) battery terminal. 2. Remove the overhead console. 3. Remove the overhead console cover after loosening the screws...
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection...
Components and Components Location Component Location 1. Rear glass defogger relay Smart Junction Block (SJB)2. Rear glass defogger switch3. Rear glass defogger Rear Glass Defogger Printed Heater Repair procedures Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line...