Hyundai Sonata: Air Conditioning System / Ambient Temperature Sensor Description and Operation

Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.
The sensor output will be used for discharge temperature control, temperature regulation door control, blower motor level control, mix mode control and in-car humidity control.

   
If the ambient temperature is below 1.0°C (33.8°F), the A/C compressor will stop.
The compressor will operate manually.
Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will ri ...

Ambient Temperature Sensor Repair procedures
Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature. 1. Ambient Sensor (+)2. Sensor ground ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Front Hub - Axle Repair procedures
Replacement Front hub assembly 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub. Tightening t ...

Hyundai Sonata LF 2014-2019 Service Manual: Blower Unit Components and Components Location
Component Location 1. Blower unit assembly Components 1. Intake actuator2. Intake case [LH]3. Intake door assembly4. Air filter5. Filter cover assembly6. Intake inlet seal 7. Intake case [RH]8. Intake outlet seal 9. Blower upper cover10. Blower unit pad11. Blower lower case12. Resistor13 ...

© 2018-2021 www.hsonatalf.org