Hyundai Sonata: Wipers and washers / Windshield Wipers

Operates as follows when the ignition switch is in the ON position.

MIST : For a single wiping cycle, push the lever upward and release. The wipers will operate continuously if the lever is held in this position.

OFF : Wiper is not in operation.

INT : Wiper operates intermittently at the same wiping intervals. To vary the speed setting, move the speed control lever.

LO : The wiper runs at a lower speed.

HI : The wiper runs at a higher speed.

Information

If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.

If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.

Wipers and washers
A : Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent control wipe time adjustment C :Wash ...

Windshield Washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will continue until you release the lev ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Ignition Coil Specifications
Specification ItemSpecification Primary Coil Resistance (?)0.56 ± 10% [20°C (68°F)]Secondary Coil Resistance (k?)2.0 ± 15% [20°C (68°F)] ...

Hyundai Sonata LF 2014-2019 Service Manual: Input shaft speed sensor 2 Specifications
Specification ItemSpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output signal (mA)High: 11.8 ~ 16.8Low: 5.9 ~ 8.4 ...

© 2018-2023 www.hsonatalf.org