Hyundai Sonata: Trunk Lid / Trunk Lid Key Holder Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Loosen the trunk lid key holder mounting nuts.
3.
Remove the trunk lid key holder (B) and disconnect the trunk lid key holder cable (A).

Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure the trunk lid locks / unlocks and opens / closes properly.
Replace any damaged clips.
Trunk Lid Trim Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

Trunk Lid Back Panel Components and Components Location
Component Location 1. Trunk lid back panel ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Sunvisor Components and Components Location
Component Location 1. Sunvisor2. Retainer ...

Hyundai Sonata LF 2014-2019 Service Manual: Alternator Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise to loosen tension. 3. Remove the drive belt (A). 4. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cab ...

© 2018-2021 www.hsonatalf.org