| Component |

Description and OperationDescription System Overview The System offers the following features: - Human / machine interface through a 1-stage button, for terminal switching and engine start...
Start/Stop Button Repair proceduresRemoval 1. Disconnect the negative(-) battery terminal. 2. Remove the center facia panel. (Refer to Heating, Ventilation and Air Conditioning - "Controller") 3...
Removal When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the case of installing used ECM] 1. Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel...