Hyundai Sonata LF: General Information / Special Service Tools

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / General Information / Special Service Tools

Special Service Tools
Tool (Number and name)
Illustration
Use
09880-4F000
Hog ring clip installer

Hog ring clip installation

    Troubleshooting

    Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panorama sunroofDirt accumulated in drain tubeClear dirt inside of drainClogged drain tubeBlow air into drain to remove dirtBroken or dislocated drain tube, defective or cracked clipCheck tube installation and flange contactDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panorama sunroofLoosen or deformed deflector, gaps in body workRetighten adjust or replaceMisaligned weather stripReadjust or replace weather stripSunroof lid makes a noise when moveForeign particles lodged in guide railCheck drive cable and guide rails for foreign particlesLoosen guide rails and lidRetightenMotor runs but panorama sunroof does not move or moves only partiallyForeign particles lodged in guide railAdjust or replaceIncorrect engagement of motor pinion with drive cableDecrease in motor`s clutch slipping forceIncreased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

    Body Dimensions

    ..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Rear Door Window Glass Repair procedures


    Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 3. Remove the rear door belt outside weatherstrip (A). 4. After loosening the mounting screws, then remove the rear door delta garnish (A)...

    Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Repair procedures


    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org