| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.
|
| 3. |
If it is necessary to replace the bulb, remove the bulb (A) after disengaging the room lamp lens. |
| 4. |
Disengage the room lamp (B) after loosening the mounting screws.
|
| 5. |
Remove the room lamp assembly after disconnect the room lamp connector. |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Separate the room lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| 1. |
Separate the vanity Lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| Installation |
| 1. |
Install the room lamp after connect the connector. |
| 2. |
Install the room lamp lens |
| 3. |
Connect the negative (-) battery terminal. |
| 1. |
Install the room lamp after connect the connector. |
| 2. |
Connect the negative (-) battery terminal. |
| 1. |
Install the vanity lamp. |
| 2. |
Connect the negative (-) battery terminal. |
Head Lamps Repair proceduresInspection 1. Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) 2. Check the fuse and relay. 3. Check the polarity of ballast...
Overhead Console Lamp Repair proceduresInspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...
Inspection • In principle, the transmission oil is maintenance-free, and no exchange is required. But it must be inspected and replenished every 4 years or 40,000 miles. 1. Park the vehicle on flat ground and turn off the engine...
Troubleshooting SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Loose or improperly installed engine flywheel.Repair or replace the flywheel as required.Worn piston rings.(Oil consumption may or may not cause the engine to misfire...