| Replacement |
| 1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
| 2. |
Remove the rear door side curtain assembly.
(Refer to Rear Door - "Rear door side curtain assembly") |
| 3. |
After loosening the mounting screws, then remove the rear door inside handle (A).
|
| 4. |
Install in the reverse order of removal.
|
Rear Door Trim Repair proceduresReplacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
C..
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder...