Hyundai Sonata LF: Seat Electrical / Power Seat Motor Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Repair procedures

Inspection

Diagnosis with GDS

The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).

The diagnostic system (GDS) provides the following information.

(1)	Self diagnosis : Checking the failure code (DTC) and display

(2)	Current data : Checking the system input/output data state

(3)	Actuator test : Checking the system operation condition

(4)	Additional function : Other controlling such as he system option and zero point adjustment

2.	Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.

3.	Select the "Power Seat Module (PSM)" to check the power seat module (PSM).

4.	Select the "Current Data" menu to search the current state of the input/output data. The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.

5.	If you will check the power door lock operation forcefully, select "Actuation test".

Power Seat Motor

1.	Disconnect the connectors for each motor. [Slide Motor] [Rear Height Motor] [Front Height Motor] [Reclining Motor] [Lumbar Support Motor]

2.	With the battery connected directly to the motor terminals, check if the motors run smoothly.

3.	Reverse the connections and check that the motor turns in reverse.

4.	If there is an abnormality, replace the motors. [Driver / Assist]

Reclining Motor Limit Switch

The power seat motor(IMS specification) mounted in this vehicle uses the hole sensor to calculate the maximum operation distance, so it does not require limit switch.

But, NON- IMS specification driver seat and passenger seat have limit switches in the motor in the back of the chairs.

1.	Disconnect the limit switch and operate the limit switch.

2.	Check for continuity between the terminals.

3.	Make sure that the seat operation is normal in the reverse after the maximum operation.

4.	If there is an abnormality, replace the limit switch.

Remove

Front Seat

1.	Disconnect the battery terminals.

2.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

Power Seat Motor Components and Components Location

Component Location 1. Slide motor2. Front height motor3. Air ventilation seat blower4. Reclining motor5. Lumbar support motor (Vertical)6. Lumbar support motor (Horizontal)7...

Power Seat Control Switch Schematic Diagrams

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Description and Operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element...

Hyundai Sonata LF 2014-2019 Service Manual: Thermostat Troubleshooting