Hyundai Sonata: Ignition System / Ignition Coil Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).

4.
Remove the ignition coil (A).

   
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.
Install in the reverse order of removal.

Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection
1.
Measure the primary coil resistance between terminals 1 and 2.


Standard value: 0.56? ± 10%

Ignition Coil Schematic Diagrams
Circuit Diagram ...

Spark Plug Description and Operation
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture there ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Rear Door Outside Handle Repair procedures
Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the rear door outside handle cover (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) 3. Remove the rear door outside handle (A) by sliding it rearward. 4. Install ...

Hyundai Sonata LF 2014-2019 Service Manual: RCV Control Solenoid Valve Description and Operation
Description RCV (Recirculation Valve) Control Solenoid Valve is installed on the cooling pan motor top and operates the RCV actuator which controls the by-pass passage of the turbo-charger compressor. When the throttle valve is closed during engine running [Tip-out], crash noise of the imp ...

© 2018-2025 www.hsonatalf.org