| Troubleshooting |
| Trouble Symptom | Probable cause | Remedy |
| Vehicle pulls to one side | Scoring of driveshaft ball joint | Replace |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Defective front suspension and steering | Adjustment or Replace | |
| Vibration | Wear, damage or bending of driveshaft | Replace |
| Driveshaft rattle and hub serration | Replace | |
| Wear, rattle or scratching of wheel bearing | Replace | |
| Shimmy | Defective wheel balance | Adjustment or Replace |
| Defective front suspension and steering | Adjustment or Replace | |
| Excessive noise | Wear, damage or bending of driveshaft | Replace |
| Rattle of driveshaft and worn hub splines | Replace | |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Loose hub nut | Adjustment or Replace | |
| Defective front suspension and steering | Adjustment or Replace |
Special Service ToolsSpecial Service Tools Tool(Number and Name)IllustrationUse09495-3K000Band installerInstallation of ear type boot band09495-33000PullerRemoval of spider assembly from a drive shaft...
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench [Hex 14] (A). Tightening torque : 4.0 ± 1.0 N.m (0.41 ± 0.1 kgf.m, 2.95 ± 0.72 lbf-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier...
C..