Hyundai Sonata LF: Steering System / Steering wheel

Hyundai Sonata LF 2014-2019 Service Manual / Steering System / Steering wheel

Components and Components Location

Components

1. Lower cover
2. Steering wheel
3. Clock Spring

4. Driver Airbag (DAB)
5. Remote control switch

Repair procedures

Replacement

1.	Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.

2.	Turn the steering wheel so that the front wheels can face straight ahead.

3.	Remove the airbag module.

Remove the DAB module.

(1)	Disconnect the air bag connector (A).

(2)	Disconnect the horn connector (B).

(3)	Remove the clip (C).

Loosen the steering wheel lock bolt properly. Separate the steering wheel by using SST(09561-11001).

Tightening torque :

39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

6.	Loosen the steering wheel lock bolt completely, remove the steering wheel.

7.	Installation is the reverse of the removal.

Disassembly

1.	Disconnect the steering wheel remote switch connector (A) & (B).

2.	Loosen the screw and then remove the lower cover.

3.	Seperate the remote control switch from the steering wheel.

4.	Reassembly is reverse of the disassembly.

Heated Steering wheel Description and Operation

Description

Heated pads to grip the steering grip makes the fever.

Heated control unit

Type	Temperature	Remarks
Leather	38°C±4°C	Apply to the entire lather surface

2.	Heated steering control : BCM(body control module) integrated management

3.	heated steering pad

Operation

The push-return switch transmits signals to the steering wheel heating module.

Pressing the switch on once repeatedly cycles the unit between the ON and OFF modes.

If the power is cut off during operation, the switch is reset to off status.

Therefore steering wheel heating module is initialized to off status.

Heated Steering wheel Schematic Diagrams

Schematic diagram

Terminal function

Pin No	Function
A2	Heated steering power
A3	Swtich signal
A13	NTC (-)
C9	NTC (+)

Heated Steering wheel Repair procedures

Inpection

Measure a resistance of NTC and Heated pad.

A.	NTC resistance(Black / Yellow, Black) - 10.0 k? ± 10% (25°C)

B.	Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 ? ± 10%

Measure a temperature.

A.	The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute

B.	The temperature of wheel surface grip must keep 38°C ± 4°C after 25 minute

C.	At that time switch on, all measure point (1~8)

General Information

Specifications Specifications ItemSpecification Type Moter Driven Power SteeringSteering GearTypeRack & PinionSteering angle (Max.)Inner40...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures

Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester...

Hyundai Sonata LF 2014-2019 Service Manual: Intake Manifold Repair procedures

Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Disconnect the engine wiring connector and haness clamp and disconnect the wiring from intake manifold. 4. Disconnect the PCV (Positive crankcase ventilation) hose (A) and the PCSV (Purge control solenoid valve) (B)...