| Components |

Side Impact Sensor (SIS) Description and OperationDescription Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH)...
Side Impact Sensor (SIS) Repair proceduresRemoval Pressure Side Impact Sensor • Removal of the airbag must be performed according to the precautions/procedures described previously...
Removal [General Type] 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A). Be careful not to damage to the wheel cap(A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refer to Body - "Floor Console Assembly") 4. Pull up the lock (C), of the SRSCM connector, then disconnect the connector (A and B)...