| Removal |
The side airbag cannot be disassembled from the seat back
assembly, so replace the seat back assembly when replacing the side
airbag. |
| 1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
| 2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
| 3. |
Remove the seat back assembly.
(Refer to Body - "Front Seat Back Assembly") |
| 4. |
Loosen the SAB mounting nuts (A) and remove the SAB module.
|
| Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts. |
|
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Install the new seat back assembly.
(Refer to Body - "Front Seat Back Assembly") |
| 4. |
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
| 5. |
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts. |
| 6. |
Reconnect the battery negative cable. |
| 7. |
After installing the side airbag (SAB), confirm proper system operation :
|
Curtain Airbag (CAB) Module Description and OperationDescription Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse...
Components 1. Turbo manifold gasket2. Turbo manifold module3. Turbo charger coupler4. Turbo charger coupler & gasket5. Oil feed pipe & hose assembly6. Oil drain pipe assembly7. Turbo manifold module heat protector8. Turbo charger water pipe & hose assembly9...