| Components (1) |

| 1. Shift lever knob 2. Shift lever assembly | 3. Shift cable 4. Shift cable retainer |
| Components (2) |

| 1. Shift lever assembly 2. P position switch 3. shift lock solenoid | 4. Main connector 5. Manual mode siwtch housing |
Inhibitor Switch Repair proceduresInspection • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage...
Removal 1. Disconnect the battery (-) terminals. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly") 3. Remove the multimedia jack (A) after disconnect the connector and loosening the mounting screws. Installation 1...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...