Hyundai Sonata LF: Rear Suspension System / Rear Stabilizer Bar Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Repair procedures

Replacement
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap (A).

   
Be careful not to damage to the wheel cap (A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
4.
Loosen the nut and then remove the rear stabilizer link (B) with the rear rear carrier.

Tightening torque :
78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.9 ~ 72.3 lb-ft)

5.
Loosen the mounting bolt and then remove the stabilizer bar with the sub frame.

Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.

    Trailing Arm Repair procedures

    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it...

    Rear Coil Spring Repair procedures

    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Gear Actuator Assembly Repair procedures


    Removal     • When gear actuator removing, set control shaft lever to neutral position. 1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner") 2. Remove the battery and tray...

    Hyundai Sonata LF 2014-2019 Service Manual: Purge Control Solenoid Valve (PCSV) Description and Operation


    Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org