| Replacement |
| 1. |
Pull down rear door window glass by pressing the power window glass switch. |
| 2. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
| 3. |
Remove the rear door belt outside weatherstrip (A).
|
| 4. |
After loosening the mounting screws, then remove the rear door delta garnish (A).
|
| 5. |
Completely loosen the rear door channel mounting bolt and
loosen the nuts as much as you can without the nuts removed from the
rear door panel.
|
| 6. |
Slightly push the rear door channel like the direction of the arrow in the picture below.
|
| 7. |
Remove the rear door window glass mounting hole plug (A).
|
| 8. |
Carefully adjust the rear door window glass (A) until you can
see the bolt, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
| 9. |
Install in the reverse order of removal.
|
Removal Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel") 2. AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate") 3...
C..