Hyundai Sonata LF: Engine Control System / RCV Control Solenoid Valve Specifications

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / RCV Control Solenoid Valve Specifications

Specification
Item
Specification
Coil Resistance(?)
28.3 ~ 31.1 [20°C(68°F)]

    RCV Control Solenoid Valve Description and Operation

    Description RCV (Recirculation Valve) Control Solenoid Valve is installed on the cooling pan motor top and operates the RCV actuator which controls the by-pass passage of the turbo-charger compressor...

    RCV Control Solenoid Valve Schematic Diagrams

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Troubleshooting


    Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panorama sunroofDirt accumulated in drain tubeClear dirt inside of drainClogged drain tubeBlow air into drain to remove dirtBroken or dislocated drain tube, defective or cracked clipCheck tube installation and flange contactDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panorama sunroofLoosen or deformed deflector, gaps in body workRetighten adjust or replaceMisaligned weather stripReadjust or replace weather stripSunroof lid makes a noise when moveForeign particles lodged in guide railCheck drive cable and guide rails for foreign particlesLoosen guide rails and lidRetightenMotor runs but panorama sunroof does not move or moves only partiallyForeign particles lodged in guide railAdjust or replaceIncorrect engagement of motor pinion with drive cableDecrease in motor`s clutch slipping forceIncreased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

    Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures


    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org