| Inspection |
| 1. |
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
|
| 2. |
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester. |
| 3. |
Select the "Power Seat Module (PSM)" to check the power seat module (PSM). |
| 4. |
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked. |
| 5. |
If you will check the power door lock operation forcefully, select "Actuation test". |
| 1. |
Disconnect the connectors for each motor.
[Slide Motor]
[Rear Height Motor]
[Front Height Motor]
[Reclining Motor]
[Lumbar Support Motor]
|
| 2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
| 3. |
Reverse the connections and check that the motor turns in reverse. |
| 4. |
If there is an abnormality, replace the motors.
[Driver / Assist]
|
The power seat motor(IMS specification) mounted in this
vehicle uses the hole sensor to calculate the maximum operation
distance, so it does not require limit switch.
But, NON- IMS specification driver seat and passenger seat have limit switches in the motor in the back of the chairs. |
| 1. |
Disconnect the limit switch and operate the limit switch. |
| 2. |
Check for continuity between the terminals. |
| 3. |
Make sure that the seat operation is normal in the reverse after the maximum operation. |
| 4. |
If there is an abnormality, replace the limit switch.
|
| Remove |
| 1. |
Disconnect the battery terminals. |
| 2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
Power Seat Motor Components and Components LocationComponent Location 1. Slide motor2. Front height motor3. Air ventilation seat blower4. Reclining motor5. Lumbar support motor (Vertical)6. Lumbar support motor (Horizontal)7...
Front Wheel Alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead...
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops...