| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door quadrant inner cover (A).
|
| 3. |
Disconnect the power door mirror connector from the harness.
|
| 4. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
[Mirror Control (LH/RT)]
[Puddle Lamp]
[BSD Indicator]
[Mirror Heater]
[Side Repeater Lamp]
|
| 1. |
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
|
| 2. |
Select the "Car Model' and the system to be checked in order to check the vehicle with the tester. |
| 3. |
Select the "Body Control Module (BCM)" to check the driver seat or assistant door module (DDM/ADM). |
| 4. |
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked.
|
| 5. |
If you will check the power door lock operation forcefully, select "Actuation Test". |
Replacement [Steering Column Shroud Upper Panel] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Removal 1. Loosen the drain plug (A), and drain the engine coolant. Remove the radiator cap to drain with speed. System is under high pressure when the engine is hot.To avoid danger of releasing scalding engine coolant, remove the cap only when the engine is cool...