| Signal Waveform |

Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench [Hex 14] (A). Tightening torque : 4.0 ± 1.0 N.m (0.41 ± 0.1 kgf.m, 2.95 ± 0.72 lbf-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. emove the rear seat cushion. ( Refer to Body - "Rear Seat Assembly") 3. Remove the fuel pump service cover (A). 4. Disconnect the fuel pump control module connector (A)...