| Replacement |
| 1. |
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
|
| 2. |
Install in the reverse order of removal.
|
Hood Lift Repair proceduresReplacement • When removing and installing the hood lift, an assistant is necessary. • When removing the hood lift, first remove the lower portion and then upper portion...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel...
Removal • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...