| Inspection |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the fuel pressure regulator valve connector. |
| 3. |
Measure resistance between the fuel pressure regulator valve terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
|
Canister Close Valve (CCV) Description and OperationDescription Canister Close Valve (CCV) is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosphere when leakage detecting system operates...
Description System Diagram Driver Door Module (DDM) Driver Door Module (DDM) is part of CAN configuration, communicating with BCM, SMK, SJB, PSM, and ADM via CAN while performing wired signal I/Os with safety power windows. Operate the buttons of DDM located on the inner side of the driver door to perform any functions related to power windows, electric mirror, and door lock/unlock...
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...