| Replacement |
|
|
| 1. |
After loosening the mounting clips, then remove the front door quadtant inner cover (A).
|
| 2. |
Using a flat-tip or remover, remove the front door pull cap (A).
|
| 3. |
Pull the front door inside handle using a flat head
screwdriver and remove the cap (A) using the hole located inside of the
handle.
|
| 4. |
After loosening the mounting screws, then remove the front door trim (A) by using a flat-tip screwdriver.
|
| 5. |
Remove the front door inside handle cage (A). |
| 6. |
Remove the front door extension connector (B).
|
| 7. |
Install in the reverse order of removal.
|
Front Door Inside Handle Repair proceduresReplacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosening the mounting screws, then remove the front door inside handle (A)...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...
General Information The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the driver, passenger, side airbag and belt pretensioner in certain frontal or side collisions...