Hyundai Sonata LF: Charging System / Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Electrical System / Charging System / Description and Operation

Description
The charging system included a battery, an alternator with a built-in regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system. The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley. The brush holder contains a built-in electronic voltage regulator.
Alternator Management System
Alternator management system controls the charging voltage set point in order to improve fuel economy, manage alternator load under various operating conditions, keep the battery charged, and protect the battery from over-charging. ECM controls generating voltage by duty cycle (charging control, discharging control, normal control) based on the battery conditions and vehicle operating conditions.
The system conducts discharging control when accelerating a vehicle. Vehicle reduces an alternator load and consumes an electric power form a battery.
The system conducts charging control when decelerating a vehicle. Vehicle increases an alternator load and charges a battery.

    Charging System

    ..

    Repair procedures

    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures


    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...

    Hyundai Sonata LF 2014-2019 Service Manual: Radiator Repair procedures


    Removal and Installation 1. Remove the cooling fan. (Refer to Cooling System - "Cooling Fan") 2. Loosen the drain plug, and drain the coolant. 3. Remove the radiator cap to speed draining. 4. Remove the radiator upper hose (A) and lowr hose (B)...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org