| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
| 2. |
Disconnect the ASCC ECU connector (A). |
| 3. |
Remove the ASCC ECU (C) after remove the installation nut (B).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
| Adjustment |
Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur...
Removal When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the case of installing used ECM] 1. Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2...