Hyundai Sonata: Front Suspension System / Front Strut Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Front Suspension System / Front Strut Assembly Repair procedures

Replacement

1.	Raise the vehicle, and make sure it is securely supported.

Remove the wheel cap (A).

Be careful not to damage to the wheel cap (A) when removing the it.

Remove the front wheel and tire (A) from front hub.

Tightening torque :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel and tire (A).

Loosen the stabilizer link (A) and remove it from the shock absorber.

Tightening torque :

98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

5.	Loosen the wheel speed sensor bracket bolt (A) and brake hose bracket (B).

Disconnect the front strut assembly (A) with the knuckle by loosening the bolt & nut.

Tightening torque :

196.1 ~ 215.7 N.m (20.0 ~ 22.0 kgf.m, 144.7 ~ 159.1 lb-ft)

Remove the front strut assembly and than loosen the strut mounting nuts (A).

Tightening torque :

53.9 ~ 73.5 N.m (5.5 ~ 7.5 kgf.m, 32.5 ~ 39.8 ~ 54.2 lb-ft)

8.	Installation is the reverse of removal.

Disassembly

1.	Compress the coil spring (A) with a SST (09546-26000). Do not compress the spring more than necessary.

2.	Loosen the self locking nuts (C) from the strut (B).

3.	Remove the insulator, spring seat, coil spring and dust cover from the strut assembly.

4.	Reassembly is the reverse of the disassembly.

Inspection

1.	Check the strut bearing for wear and damage.

2.	Check the spring upper and lower seat for damage and deterioration.

Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal

(1)	Fully extend the piston rod.

(2)

Drill a hole on the (A) section to remove gas from the cylinder.

•	The gas coming out is harmless but be careful of chips that may tly when driling.

Front Strut Assembly Components and Components Location

Components 1. Strut assembly2. Insulator3. Strut bearing4. Spring upper pad5. Coil spring6. Dust cover7. Bumper rubber8. Spring lower pad ...

Front Lower Arm Repair procedures

Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: EPB Switch Repair procedures
Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console assembly. (Refer to Body - “Floor console assembly") 3. Remove the EPB switch after loosening the screws. 4. Install in the reverse order of removal. ...

Hyundai Sonata LF 2014-2019 Service Manual: Boost Pressure Sensor (BPS) Repair procedures
Inspection 1. Connect a GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the boost pre ...