| Replacement |
| 1. |
Remove the hole plug (B). |
| 2. |
After loosening the mounting bolt, then remove the front door lock (A).
|
| 3. |
Remove the front door outside handle (A) by sliding it rearward.
|
| 4. |
Disconnect the front door outside handle connector (A).
|
| 5. |
Install in the reverse order of removal.
|
Front Door Belt Outside Weatherstrip Repair proceduresReplacement 1. Pull down front door window glass by pressing the power window glass switch. 2. Remove the front door belt outside weatherstrip (A)...
Removal OCS ECU 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat assembly. (Refer to Body - "Front Seat Assembly") 3. Disconnect the OCS ECU connector (A)...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...