Hyundai Sonata: Front Seat Belt / Front Seat Belt Retractor Repair procedures

Replacement
   
When installing the belt, make sure not to damage the retractor.
1.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
3.
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
After disconnecting the connectors (A) by pushing the lock pin, loosen the mounting bolts, and then, remove the front seat belt retrator (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damaged clips.
Front Seat Belt Retractor Components and Components Location
Component Location 1. Front seat belt retractor ...

Height Adjust Components and Components Location
Component Location 1. Height adjust ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper. 3. Remove the wiring fixing clip (C) and disconnect the horn connector (A). ...

Hyundai Sonata LF 2014-2019 Service Manual: Under Body Body Repair
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O ...

© 2018-2025 www.hsonatalf.org