| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the trunk, remove the right luggage side trim.
(Refer to Body - "Trunk Trim") |
| 3. |
Remove the external amplifier (B) after disconneting the connector (A) and loosening the mounting nuts.
|
| Installation |
| 1. |
Install the external amplifier after connecting the connector. |
| 2. |
Install the right luggage side trim. |
| 3. |
Connect the negative (-) battery terminal.
|
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off...
Removal • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...