| Description |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Rmove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector...
Removal Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. 1. Drain engine coolant so that its level would be under the thermostat height. 2. Remove the radiator lower hose...