| Description |
This system is a supplementary function only. It is the
responsibility of the driver or always check the inside/ outside
rearview mirror and the area behind the vehicle before and while backing
up because there is a dead zone that can't see through the camera. |
Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lide trim. (Refer to Body - "Trunk Lid Trim") 3. Disconnect the back view camera connector (A)...
Inspection 1. Connect a GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...
C..