Hyundai Sonata: Cruise Control System / Cruise Control Switch Repair procedures

Inspection
[Measuring Resistance]
1.
Disconnect the cruise control switch connector from the control switch.

2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance
SET -
3 - 5
550?±5%
RES +
3 - 5
880?±5%
CANCEL
3 - 5
330?±5%
CRUISE
3 - 5
1.4k?±5%

3.
If not within specification, replace switch.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screw.

Installation
1.
Install in the reverse order of removal.
Cruise Control Switch Schematic Diagrams
Circuit Diagram ...

Advanced Smart Cruise Control System
...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Specifications
Specification Service Standard DescriptionSpecificationOperating voltage8 ~ 16VOperating temperature-40 ~ 85°C(-40 ~ 185°F)Current consumptionMax.150mAMeasuring rangeAngle-780 ~ 779.9°Angular velocity0 ~ 1016°/secOutput signalCAN Interface ...

Hyundai Sonata LF 2014-2019 Service Manual: Wheel Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tightening torque should be checked using a torque wrench. Run out inspection 1. Jack up the vehicl ...

© 2018-2023 www.hsonatalf.org