| Description |


Description and OperationDescription Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components...
Catalytic Converter Repair proceduresRemoval 1. Remove the exhaust manifold. (Refer to Engine Mechanical System - "Exhaust Manifold") Installation 1. Install in the reverse order of removal...
Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. NoProcedure1Locate vehicle to flat plane2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic tool10Checking of HLLD output value as 15% and DTC Code11HLLD actuating by diagnostic tool command12Head lamp mechanical Initial Aiming 1...
Inspection 1. Remove the cowl top cover. (Refer to Body - "Cowl Top Cover") 2. Disconnect the windshield deicer connector (A). 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector...