| Troubleshooting |

Battery Repair proceduresRemoval 1. Remove the air duct. (Refer to Engine Mechanical System - "Air Cleaner") 2. Disconnect the battery (-)terminal (A) and then (+)terminal (B)...
Battery Sensor Description and OperationDescription Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors...
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot...
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder...