Hyundai Sonata: Audio / Audio Remote Control Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Audio / Audio Remote Control Repair procedures

Inspection
1.
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
SEEK Up
2-5
430 ?
SEEK Down
1.11 k?
MODE
2.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
SEND
18.91 k?
END
40.91 k?

2.
Check for resistance between terminals in each switch position (RH).

[RH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
Cancel
3-5
330 ?
SET (-)
550 ?
RES (+)
880 ?
Cruise ON/OFF
1.44 k?
SCC (Following distance control)
5.54 k?
Group
2-5
560 ?
Trip Up
890 ?
Trip Down
1.45 k?
ENTER
2.55 k?

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screws.

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Connect the negative (-) battery terminal.
Audio Remote Control Schematic Diagrams
Circuit Diagram ...

Audio Remote Control (Sonata Sports) Components and Components Location
Components 1. Left remote control switch (Audio + Hands free)2. Right remote control switch (Cruise+Trip Computer)3. Paddle shift switch (Down)4. Paddle shift switch (Up) ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Front Seat Cushion Cover Components and Components Location
Component Location 1. Front seat cushion cover ...

Hyundai Sonata LF 2014-2019 Owners Manual: BSD (Blind Spot Detection) / LCA (Lane Change Assist)
Operating conditions To operate: Press the BSD switch with the Engine Start/Stop button in the ON position. The indicator illuminates on the switch. If vehicle speed exceeds 20 mph (30km/h) the system will activate. To cancel: Press the BSD switch again. The indicator on the switch will go off. W ...

© 2018-2025 www.hsonatalf.org