| Inspection |
| 1. |
Turn the ignition key to the "ON" position. |
| 2. |
Cover the forward facing sensor. |
| 3. |
Head a light to the rearward looking sensor. |
| 4. |
The ECM should be darkened as soon as the rearward looking sensor detects the light.
|
| 5. |
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the forward facing and rearward looking sensors, the ECM should not be darkened. |
| Removal |
| 1. |
Remove the mirror wiring cover (A).
|
| 2. |
Remove the mirror connector (A).
|
| 3. |
Remove the mirror (A) pulling up in the arrow direction.
|
| Installation |
| 1. |
Install the mirror making sure the mounting bracket not to be damaged. |
| 2. |
Install the mirror wiring cover and rain sensor cover after reconnecting the connector and tightening the screw. |
Description and OperationDescription The ECM (Electro Chromatic inside rear view Mirror) is intended dim the reflecting light in the rear view mirror. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor is for the light from the rear...
Removal [For C-MDPS Type] Must be backup the ECU data before exchanging the ECU. The backup data is stored by the VIN number. Before exchanging the MDPS motor, must be confirm the last two digit of the constant value in motor barcord...
Smart Key Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. Select the vehicle model and then do "Smart Key Code Saving". 3. After selecting "Smart Key Teaching" menu, push "ENTER" key, then the screen will be shown as below...