Hyundai Sonata LF: Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the front seat. (Refer to Body - "Front Seat Assembly")

3.	Remove the rear seat. (Refer to Body - "Rear Seat Assembly")

Remove the front anchor seat belt (A).

When replacing anchor pretensioner, make sure to use the assigned tools to remove the anchor safety belt connector (A).

Tools to be used

Tool A: hex wrench screwdriver or drill with diameter of 3 mm and length of 56 mm or more.

Tool B: screwdriver or drill with diameter of 3 mm.

(1)

Insert the tool (A) vertically into the hole (F). Then, tilt it over 10° as shown in the figure.

When tilted 10°, tool (A) pushes and rotates the internal part (C).

(2)	Insert and push the tool (B) vertically into the hole (E). Then, anchor safety belt connector (D) will be disconnected.

5.	Remove the door scuff trim. (Refer to Body - "Interior Trim")

6.	Remove the center pillar trim. (Refer to Body - "Interior Trim")

7.	Remove the floor carpet assembly. (Refer to Body - "Floor Carpet")

8.	Disconnect the anchor pretensioner (A)

9.	Loosen the monuting bolt (B) and remove the anchor pretensioner

Installation

1.	Installation is reverse of removal.

2.	Connect the battery (-) terminals.

Emergency Fastening Device (EFD) Components and Components Location

C..

Brake System

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Assist Handle Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...

Hyundai Sonata LF 2014-2019 Service Manual: Engine Mounting Repair procedures