Hyundai Sonata LF: Blower / Intake Actuator Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Intake Actuator Description and Operation

Description
The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.

    Intake Actuator Components and Components Location

    C..

    Intake Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Brake Line Repair procedures


    Removal 1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder reservior with a syringe.     Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water...

    Hyundai Sonata LF 2014-2019 Service Manual: Wheel Repair procedures


    Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tightening torque should be checked using a torque wrench...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org