Hyundai Sonata: What to do in an emergency / If the Engine Will Not StartIf the Engine Will Not Start
If the Engine Doesn’t Turn Over or Turns Over Slowly
- Be sure the shift lever is in N (Neutral) or P (Park). The engine starts only when the shift lever is in N (Neutral) or P (Park).
- Check the battery connections to be sure they are clean and tight.
- Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained.
Do not push or pull the vehicle to start it. This could cause damage to your vehicle. See instructions for "Jump Starting" provided in this chapter.
CAUTION
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
If the Engine Turns Over Normally but Doesn’t Start
Check the fuel level and add fuel if necessary.
If the engine still does not start, have your vehicle checked by an authorized HYUNDAI dealer.
In Case of an Emergency While Driving
If the Engine Stalls While Driving
Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
Turn on your hazard warning flasher.
Try to start the engin ...
Jump Starting
Jump starting can be dangerous if done incorrectly. Follow the jump starting
procedure in this section to avoid serious injury or damage to your vehicle. If
in doubt about how to properly jump start ...
Other information:
Hyundai Sonata LF 2014-2019 Owners Manual: Changing tires
WARNING
A vehicle can slip or roll off of a jack causing serious injury or death to
you or those nearby. Take the following safety precautions:
Never place any portion of your body under a vehicle that is supported
by a jack.
NEVER attempt to change a tire in the lane of traffic. ALWAYS move t ...
Hyundai Sonata LF 2014-2019 Service Manual: Schematic Diagrams
Circuit Diagram
NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2-- ...
