| Replacement |
| 1. |
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass") |
| 2. |
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle") |
| 3. |
Loosen the rear door outside handle base mounting bolt (A).
|
| 4. |
After loosening the mounting bolt and nuts, then remove the rear door channel (A).
|
| 5. |
Loosen the rear door latch (A) mounting screws. |
| 6. |
After loosening the mounting bolts, then remove the rear door module (B).
|
| 7. |
Disconnect the connectors and front door module wiring harness (A).
|
| 8. |
Remove the rear door latch assembly.
(Refer to Front Door - "Rear Door Latch") |
| 9. |
Reomove the rear speaker .
(Refer to Body Electrical System - "Speakers") |
| 10. |
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor") |
| 11. |
Install in the reverse order of removal.
|
Removal and Installation 1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove the pump cover (A). Tightening torque : 8.8 ~ 13.7N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft) 3. Remove the inner rotor (B) and outer rotor (C)...
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line...