| Components |





| No | Description | No | Description |
| 1 | - | 21 | Speaker (+) |
| 2 | Illumination (-) | 22 | Speaker (+) |
| 3 | Rheostat switch (Down)_Input | 23 | Immobilizer_Input |
| 4 | Rheostat switch (Up)_Input | 24 | AT ('P' Position) |
| 5 | - | 25 | AT ('R' Position) |
| 6 | Oil press switch_Input | 26 | AT ('N' Position) |
| 7 | Washer level (Low signal)_Input | 27 | AT ('D' Position) |
| 8 | Alternator_Input | 28 | AT ('S' Position) |
| 9 | LDWS_Input | 29 | Multimedia-CAN (Low) |
| 10 | Driver mode switch_Input | 30 | Multimedia-CAN (High) |
| 11 | Detent | 31 | - |
| 12 | Active ECO switch_Input | 32 | Chassis-CAN (High) |
| 13 | - | 33 | Chassis-CAN (Low) |
| 14 | Fuel sender (+)_Input | 34 | Trip switch 1 (+)_Input |
| 15 | - | 35 | Trip switch 2 (+)_Input |
| 16 | Fuel sender (-)_Input | 36 | Trip switch (-)_Input |
| 17 | Vehicle speed | 37 | GND |
| 18 | - | 38 | - |
| 19 | AIR BAG (+)_Input | 39 | IGN 1 |
| 20 | Tail lamp_Input | 40 | Battery (+) |
Replacement 1. Disconnect the negative (-) battery terminal. 2. After loosening the bolts remove the main crash pad and cowl cross bar assembly together. (Refer to Heater -"Heater Unit") 3. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 4...
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...