Hyundai Sonata LF: Front Door / Front Door Module Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the front door outside handle base mounting screw (A).

4.
Disconnect the outside rear view mirror connector (A).

5.
Loosen the front door latch (A) mounting screws.
6.
After loosening the mounting bolts, then remove the front door module (B).
Tightening torque :
Bolt: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Screw: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

7.
Disconnect the connectors and front door module wiring harness (A).

8.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch")
9.
Reomove the front speaker.
(Refer to Body Electrical System - "Speakers")
10.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
11.
Install in the reverse order of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens / closes properly.

    Front Door Module Components and Components Location

    C..

    Front Door Outside Handle Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Alternator Schematic Diagrams


    Circuit Diagram     • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower) • FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM...

    Hyundai Sonata LF 2014-2019 Service Manual: Description and Operation


    Description System Overview The System offers the following features: - Human / machine interface through a 1-stage button, for terminal switching and engine start. - Control of external relays for ACC / IGN1 / IGN2 terminal switching and STARTER, without use of mechanical ignition switch...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org