Hyundai Sonata LF: Ignition System / Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Electrical System / Ignition System / Description and Operation

Description

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

Repair procedures

On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs. • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Starter Components and Components Location

Components 1. Screw2. Front housing3. Stop ring4. Stopper5. Overrunning clutch6. Lever7. Lever plate8. Lever packing9. Magnet switch assembly10. Armature assembly11. Yoke assembly12. Brush (-)13. Brush holder14. Brush (+)15. Rear bracket16. Through bolt17...

Hyundai Sonata LF 2014-2019 Service Manual: Electric Parking Brake (EPB) Schematic Diagrams