| Components (1) |

| 1. Dual clutch transmission assembly 2. Clutch actuator 3. Gear actuator 4. Roll rod supprot bracket 5. Engine room under cover | 6. Roll rod bracket 7. Dust cover 8. Support bracket mounting bolt 9. Transmission support bracket |
| Components (2) |

| 1. Clutch actuator 2. Fork cover 3. Spline hub 4. Input shaft speed sensor 1, 2 5. Dual clutch assembly 6. Inhibitor switch 7. Maunal lever | 8. Shift cable bracket 9. Gear actuator 10. Transmission support bracket 11. Retaining ring 12. Snap ring 13. Transmission bracket hanger |
DCT (Dual Clutch Transmission) Repair proceduresRemoval 1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner") 2. Remove the TCM. (Refe to Dual Clutch Transmission Control System - "TCM") 3...
Roof Side Molding Repair procedures Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Removal • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...